Place The Cuff In Your Palm With The Center Stone Facing Down.
Repeat the first and following knotting directions before your knot is 1/2 inches long. To tighten any of your adjustable cord bracelets, pull on the string ends on each side of the slip knot. Pull the knot toward the other knot, traveling away from the knotted section to tighten it for your desired fit.
We Make All Bracelets By Hand, This Means Every Bracelet Is A Little Bit Different.
To loosen the bracelets, pull gently on the sides of the bracelet by tugging the loose strings through the slip knot. Just tie it as normal and then make braids or square knots at both ends. A little bit unique, like you!
Tie An Overhand Knot On Each Side Of The Blue Knotting Cloth And Trim Near The Knot.
Use your thumb and 1st finger to. 1 bead with a hole that’s 2x the width of your cord. Lay the watch on the table and divide.
Using Solder, A Easily Melted Alloy That Matches The Metal Of Your Bracelet, The.
Firmly grasp the bracelet on either side of the slip. Take the left piece of yarn and pull it over the middle piece. Remember to pull the end of the rope down.
Place Your Bracelet In The Position With The Face Of The Bracelet Facing Down And The Knotted Side Up Towards You.
So for my 2mm cord, i used a brass bead with a. Take the right piece and pull it over the new middle piece (the one that. Position it in the right spot.
